FINAL INSTALLATION
FINAL INSTALLATION
9. Install bulbs (L) into sockets.
10. Remove the preassembled rubber washer,
hex nut, bowl cap (M) and finial (N) from the
light kit (J)
L
9
M
N
Hex nut
Rubber washer
J
10
11. Place glass bowl (K) on the preassembled
pipe on light kit (J) until it is flush against the
metal disk. Thread fanpull chain through side
hole on glass bowl (K). Make sure pull chain
hangs clear and is not tangled in light kit (J)
socket. Thread light kit pull chain through
center hole on glass bowl (K).
NOTE:
Two people are recommended for this
step.
K
11
12. Place previously removed rubber washer and
hex nut (Step 10, page 14) onto the pipe and
securely tighten. Pass fan pull chain through
side hole on bowl cap (M), then place bowl
cap (M) and finial (N) over pipe and securely
tighten.
13. Attach fan pull chain extension (BB)
and light kit pull chain extension (CC) to
corresponding chains.
Assembly is now complete.
Rubber washer
Hex nut
M
N
12
CC
BB
13
Hardware Used
Fan pull chain extensions
x 1
BB
Light pull chain extensions
x 1
CC
14. If you do not want to use the light kit (J),
remove the two connectors from the light kit
(J), then remove the preassembled hex nut
and switch housing (I) from the light kit (J).
Hex nut
I
J
Connectors
14
15
14
