8
STANDARD/ANGLE-MOUNTING INSTRUCTIONS
Lowes.com/harborbreeze
4. Carefully lift assembly and rest the hanger ball of
downrod assembly (D) on the mounting bracket (A)
attached to the outlet box. Be sure the slot in the
hanger ball is lined up with the tab on the mounting
bracket (A). This will leave hands free for the wiring
process.
Proceed to
WIRING INSTRUCTIONS
on page 10.
DANGER:
Be careful when aligning the tab to the
slot! If not fully engaged, there is a possibility of the fan
falling, which may result in serious injury or death.
CAUTION:
Ensure all screws are tight before moving
onto the next step.
3. Cut off excess fixture wires, leaving approximately 6 to 9
inches above the top of the downrod assembly (D). Strip
1/2 inch of insulation from the end of each fixture wire.
6
to
9
in
3
Screw
2
D
H
P
O
2. Feed power wires from motor housing (H) through
downrod assembly (D), then insert downrod assembly
(D) into the coupling (E) on motor housing (H).
Align the hole on downrod assembly (D) to hole on
coupling (E), then re-install clevis pin (O). Re-attach
hairpin clip (P) into clevis pin (O) until it snaps into place,
then tighten the two previously loosened screws.
4
A
D
Hanger Ball
Tab
Slot
