12
FINAL INSTALLATION
Switch
Housing
Plate
1.
If you do NOT wish to use the light kit,
remove
three screws from switch housing plate. (Fig. 1)
Fig. 1
2. Align holes in extra switch housing (C) with holes
on outer edge of switch housing plate. (Note: The
wide gap in the top edge of the extra switch housing
(C) should align with the reverse switch on the switch
housing plate for the proper fit.) Re-insert screws that
were just removed. Use a Phillips screwdriver to
secure all screws. (Fig. 2)
Fig. 2
8. The pull chain extensions (J) supplied in one
of the hardware packs or custom pull chain
extensions (not included) may be attached to fan
and light pull chains. (Fig. 8)
C
USING FAN WITHOUT LIGHT KIT (OPTIONAL)
Switch
Housing
Plate
3. The pull chain extension (J) supplied in one of the
hardware packs or custom pull chain extension (not
included) may be attached to fan. (Fig. 3)
J
Fig. 3
1. The pull chain on the switch housing plate has four
positions to control
fan
speed. One pull is HIGH, two is
MEDIUM, three is LOW and four turns the fan OFF.
(Fig. 1)
FAN OPERATION
Fig. 9
(For Fan)
(For Light)
J
J
Fig. 1
