5. Fasten the blade bracket (F) to the motor by inserting
the alignment post into the slot on the bottom of the
motor housing (H) and tightening the blade bracket
screws with washers.
Please note that the blade bracket screws with washers
are pre-installed into the blade bracket (F). Repeat Steps
4 and 5 for the remaining blade brackets (F).
6. Attach the fan pull chain extension (BB).
13
12
5
6
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Lowes.com/harborbreeze
Lowes.com/harborbreeze
screw with
washer
alignment
post
slot
F
H
FINAL INSTALLATION
OPERATING INSTRUCTIONS
PULL CHAIN:
The fan pull chain is for motor speed control: High, Medium, Low and Off. Pull the
chain once for each position.
REVERSE SWITCH:
When the season changes, you may want to change to the direction your fan
spins. To switch between clockwise and counterclockwise rotation, flip the fan reversal switch.
Note: Wait for fan to stop before reversing the switch.
A. In cooler weather, clockwise rotation creates an upward air flow, which moves hot air from the
ceiling into the room. Push the switch UP.
B. In warmer weather, counterclockwise rotation creates a downward air flow, which cools the air.
Push the switch DOWN.
• To reduce the risk of fire, electric shock or injury to persons, maintain this fan.
•
Important:
Shut off main power supply before beginning any maintenance.
• Do not use water or detergents when cleaning the fan or fan blades. A dry dust cloth or lightly
dampened cloth will be suitable for most cleaning.
• Clean fan housing with only a soft brush or lint-free cloth to avoid scratching the finish. Clean
blades with a lint-free cloth. You may occasionally apply a light coat of furniture polish to blades for
added protection.
• At least twice each year, tighten all screws and lower canopy to check mounting bracket screws
and downrod assembly.
CARE AND MAINTENANCE
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Excessive wobbling. 1. Blades are loose. 1. Tighten all blade screws.
2. Blade brackets incorrectly attached. 2. Reinstall blade brackets.
3. Unbalanced blades. 3. Switch with blade from opposite side.
4. Fan not securely mounted. 4. Turn power off. Carefully loosen
5. Fan too close to vaulted ceiling. canopy; remount securely.
5. Lower fan or move it to another
location.
Noisy operation. 1. Blades are loose. 1. Tighten all blade screws.
2. Cracked blade. 2. Replace blades (call customer
3. Unapproved speed control. service).
3. Replace with an approved speed
control device.
Fan does not move. 1. Chain switch is “off”. 1. Pull chain switch.
2. Faulty wire connection. 2. Turn power off. Loosen canopy,
3. Reverse switch not engaged. check all connections.
3. Push switch firmly either way.
Hardware Used
x 1
Fan pull chain extension
BB
BB
