WIRING FAN
(continued from previous page)
7
1.
Remove existing wall switch and save the screws. Unscrew
screw on top and bottom of the wall control (B) and remove back
plate from wall control (B). Secure back plate to wall or structure
with screws from existing wall switch. [Fig. 1]
Make the following electrical connections:
(
Make special note of
Step 2 below while wiring.
)
Connect
BLACK
wire from wall control to
BLACK
(
AC TO FAN
)
wire from wall. Connect
BLACK
wire from wall control to
BLACK
(
AC IN
) wire from wall. [Fig. 1]
Fig. 3
3.
Screw wire connectors (G) on in a clockwise direction. Wrap
electrical tape around each individual wire connector (G) down to the
wire as shown in Fig. 3.
Warning:
Make sure no bare wire or wire strands are visible
after making connections. Place green and white connections on
opposite side of box from the black and blue (if applicable) connections.
Turn spliced/taped wires upward and gently push wires and wire
connectors (G) into outlet box.
G
G
G
back plate
back plate screw
black
black
*
black
AC IN
back plate screw
black
TO FAN
black
AC IN
WIRING WALL CONTROL
Fig. 1
outlet box
outlet box
Fig. 3
3.
Screw wire connectors (G) on in a clockwise direction. Wrap
electrical tape around each individual wire connector (G) down to
the wire as shown in Fig. 3.
Warning:
Make sure no bare wire or wire strands are visible
after making connections.
Turn spliced/taped wires in toward wall and gently push wires and
wire connectors (G) into outlet box.
G
G
4.
Attach wall control (B) to back plate using screws that were
previously removed. [Fig. 4]
Fig. 4
back
plate
screw
B
back
plate
back
plate
screw
G
G
black
TO FAN
B
2.
Strip 3/4 of an inch of insulation from ends of white wire. Twist
stripped ends of each strand of wire within the insulation with pliers.
[Fig. 2] Snip ends after twisting strands together. Repeat for black, blue
(if applicable) and green wires.
Fig. 2
2.
Strip 3/4 of an inch of insulation from ends of white wire. Twist
stripped ends of each strand of wire within the insulation with pliers.
[Fig. 2] Snip ends after twisting strands together. Repeat for black, blue
(if applicable) and green wires.
Fig. 2
