Harbinger 2AIQW-MDA350, Руководство пользователя

Страница: 12 / 16

12
M350 Owner's Manual
S E R I E S
MuV
¨
PANEL CONTROLS
Channel Input Select Switches
These switches allow you to select the correct the input setting for your device. Microphone or line inputs on channel 1, Guitar or line
inputs on channel 2 and Line or Bluetooth on channel 3.
Channel Level Controls
Each channel has separate Level controls to allow discrete mixing of each audio source.
FX Send Controls
These knobs determine the amount of send or volume being sent to the built-in effects processor.
FX Return
This knob will determine the amount of effects being returned to the mixer so you can balance the mix of the effect “wet” signal against
the “dry” input send level.
Setup Switch
Sets the system into either a mono or stereo speaker configuration.
FX Selection Control
This knob selects the effects type for the built-in effects processor.
Effects On/Off Switch
This will turn off and on the built-in effects processor.
Power LED
The Power LED is green to indicate that the M350’s power cable is connected to an electrical outlet, and the Power Switch is turned on.
EQ Controls
The LOW EQ will p/- 15dB of boost or cut below 100Hz. Turn the LOW EQ up to add bass or warmth to the speaker. The
HIGH EQ will p/- 15dB of boost or cut above 10kHz. Turn the HIGH EQ up to increase the volume of cymbals or other high
frequency sounds.
Subwoofer Volume
This controls the Subwoofer volume. The “Flat” indication on the markings around the knob indicates that the system-wide balance
between the high and low frequencies are equal. If you want more low frequencies turn the knob towards the Max indicator.
Channel Inputs
Channel 1 is intended for a line level or microphone input. Channel 2 can either be a mono line input or a guitar level input. Channel 3 can
either be a physical input source that comes into the ¼” inputs or 1/8” TRS input, or you can switch it to Bluetooth® for wireless connectivity.
Bluetooth Switch and Pair Button
To make your mobile audio device communicate with the M350 you need to make sure the device is paired. This is done by setting
your device to discover
Bluetooth devices. The Device Harbringer M350 should be present when you hold down the Pair button on the M350 while your
device is searching device. The Bluetooth light will light blue when connected and will play a chime. When your device is playing
music, the Bluetooth light will blink slowly.
When connected to Bluetooth, you can press the pair button on the M350 to stop playback of the connected device. Press the pair
button again to resume playback. To disconnect, press and hold the pair button. The light will turn off and it will play a chime.
Program/Effects Selection LEDs
The names and LEDs located next to them indicate which effect has been selected with the built-in effects processor.
1
2
3
4
5
6
7
8
9
10
11
12
13