16
10 6 14
C
G
H
G
16
H
G
2x
2x
2x
Step 5:
To install Hydraulic (H) to the Hydraulic Base Support (G), you will need to loose out the M8 HEX nut from the part (G).
After the part (H) go inside the position, put back the M8 HEX Nut and tighten it using M8 Spanner (16).
To install the complete set of (G) to the left and right side rail (C), you will need to use hardware 6 and 8 with Allen key
M5 (14).
To assemble part G, it is a must to make sure the hole go into the right position as shown in (NOTE). And before
tighten the screw, please make sure part G is in same alignment in between left and right side rail.
DO NOT
use any power tools as this may damage the bed frame and will invalidate any claims.
Page 6 of 10
* Please insert the screw end to right hand side.
6 JCBB M8 x 40mm
8 pcs
10 M8 Flat Washer
8 pcs
14 Allen Key M5
1 pc
16 M8 Spanner
1 pc
Side View
H
G
C
C
Do Not Use Power Tools
Side View
Side View
