3
1. Power Supply
This color monitor shall maintain the specified
per formance in the range described below.
Frequency : 47Hz
～
63Hz
Voltage : 90VAC-264VAC
Consumption : Less than 70Watts
2. Input Signal
The referenced video controller used for adjustment
and test will guarantee the performance described
below.
Video signals
Red, Green, Blue analog input
150
Ω
termination to ground
Level : 0 to 2.4Vp-p
Polarity : Positive
Sync signals
Separate H/V sync input
10k termination to ground
Level : TTL level
Polarity : Positive or Negative
3. Horizontal Def lection
Scanning Frequency : Nominal (15-17.5kHz)
Retrace period :
〈
11.5us
4. Vertical Deflection
Scanning Frequency : Nominal (50-65Hz)
Retrace period :
〈
900us
5. Linearity
±
5%
6. Picture Size Regulation
Static Regulation 2%
Dynamic Regulation 1.5%
7. Geometric Distortion
It is acceptable that pincushion, trapezoid, paralle-
logram, barrel distortion, out of orthogonality and
various waves can appear all together. If the data
area parameter remains within the limits of 2%.
8. Degaussing
This color monitor shall employ an automatic
degaussing circuit, The degaussing sequence
shall be self activated at the time of switch-on.
After a degaussing cycle, the demagnetizing circuit
shall recover.
9. High Voltage
This color monitor shall employ an X-radiation
shut-down protection with internal circulitry.
13" : 26KV
19" : 27KV
10. Environmental Conditions
Temperature : 10 ~ 55
℃
(Operating)
Humidity : 10 ~ 90%, no condensation
1. Apply line AC,90V-264V, in your locality to the
monitor through W801.
2. Apply signal source to the monitor through W301.
3. Set up user ad justable controls.
All controls are preset at the factory for optimum
performance. If adjustment is necessary to suit
program material, most adjustments can be made
using only the controls on the remove VR PCB.
Other controls in the monitor should be adjusted
only if those controls have been tampered with or if
major repairs were necessary on the monitor.
PERFORMANCE AND OPERATING DATA
OPERATING INSTRUTIONS
