Hanyang Navicom RFCT-10, Руководство пользователя

Страница: 7 / 25

4
2 Initial Setup
2.1 Preparation for setup
z
RFCT-10 Set
¾ Transmitter (RFCT-10 main body).
¾
AC-DC Adaptor power supply
¾
RF Transmitter Antenna
¾ GPS Antenna
z
PC and monitoring cable( refer to 4.Monitoring using PC) : optional
2.2 Setup
2.2.1 Location
The first step in setting up the transmitter is to determine a suitable location for
the transmitter and GPS unit. The transmitter's power supply requires 120 Volts
AC so proximity within reach of the transformer cord is needed. It is
recommended that the transmitter be located a minimum of 2 to 3 feet above
the floor and away from large metal objects, such as lockers, filing cabinets,
etc. The transmitted signal from the antenna radiates in a circular and
‘umbrella ’ pattern, therefore the coverage for an area will be better if the
transmitter is centrally located. In multistory buildings, locating the transmitter
on the top floor will often significantly improve coverage for the lower floors
due to the umbrella ’ pattern of transmission.
The GPS antenna needs a clear view of the sky to receive the GPS signal. Only
the cable permanently attached to the GPS unit may be used outdoors. then
additional cable is required the connection must be sealed with Radio Shack
coaxial Cable Connector Sealant 278-1645 or high quality silicone sealant to
weatherproof the connection. Any cable extensions must be protected from
outside elements.
2.2.2 Assembly of the RFCT-10
1. Carefully screw the transmitter antenna onto the transmitter. The antenna
must be snug against the case but hand-tighten only.
2. Plug the GPS unit cable into the transmitter.
3. Attach the GPS unit to the inside of a window
4. Plug the supplied 9-volt/1.5 Amp DC power supply into the transmitter.
5. Plug in the supplied 9-volt/1.5 Ampere DC power supply into a 120 VAC
outlet.
6. Set all the parameter on the transmitter using key pad.