Hanwha Vision TNO-6321E, Руководство пользователя

Страница: 10 / 21

installation & connection
10_
installation & connection
CONNECTING WITH OTHER DEVICE
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Power Supply
Connect the power supply line with the camera power supply terminal using a screwdriver.
J
`
Be sure to connect the AC24V power supply (non-polar) while the power is shut off.
Network Cable Specification
Item Contents Remark
Connector RJ45
Ethernet 10/100Base-T 10/100 Mbps
Cable UTP Category 5e
Max Distance 100m
Power Cable Specification
In case of AC24V Input:
Wire Type (AWG) #16 #14
Cable Length (Max.) 15 m 24 m
How to connect external cables for each model
Connect external cables by referring the table below.
J ` Connect alarm input/output cables for each terminals one by one.
Label print COLOR Description Remarks
GND / GRN Green
A common terminal to connect external Alarm signal
(GND)
ALARM_COM / BRN Brown
A common terminal to connect Alarm output signal
(COM)
ALARM_OUT / YEL Yellow A terminal to connect Alarm output signal
ALARM_IN / ORG Orange A terminal to connect external Alarm signal
WAS_COM / BLU Blue A common terminal to connect Washer Pump (COM)
WAS_NO / PUP Purple A terminal to connect Washer Pump (NO)
WAS_NC / WHT White A terminal to connect Washer Pump (NC)
AC24V_B Black A terminal for 24Vac power supply input (B)
AC24V_A Red A terminal for 24Vac power supply input (A)
Ethernet
External cables