Hanwha Techwin Wisenet QRN-1630S, Быстрое руководство

Страница: 3 / 6

3
Installing the HDD
■
If you are adding a new or previously used HDD to this product in addition to the HDD(s) originally installed, format the new HDD manually in the
set before use.
■
If you wish to replace or add an HDD, contact your dealer or our customer service first.
QRN-1630S/XRN-815S
■
The following figures are based on Model XRN-815S.
1 Remove the screws from the left/right sides and
back side, and push the cover back to release it. 2 Connect the SATA/power cable of the hard disk to
the connector of the main board.
■
Refer to the figure below for the hard disk location number and
connector number.
2
1
2
1
■
Gently press the connector before removing the HDD. Do not force
to pull the cable.
3 Use the screws to fix the hard disk to the bottom
of the recorder. 4 Make sure that there is no problem in the
connection port and routing inside the recorder,
and then fix it using screws after closing the cover.
■
When closing the cover, be careful not to damage the cable.
QRN-830S
1
Remove the screws from the left/right sides and
back side, and push the cover back to release it.
2
Connect the SATA/power cable of the hard disk to
the connector of the main board.
■
Refer to the figure below for the hard disk location number and
connector number.
■
Gently press the connector before removing the HDD. Do not force
to pull the cable.
3 Use the screws to fix the hard disk to the bottom
of the recorder. 4 Make sure that there is no problem in the
connection port and routing inside the recorder,
and then fix it using screws after closing the cover.
■
When closing the cover, be careful not to damage the cable.