Page EN-26
Setup or under-worktop installation and connection
0-5
H1
6-11
H2
12-17
H3
18-22
H4
23-34
H5
35-55
H6
3. Press the button (13) repeatedly until
the required hardness level is displayed.
4. Around 5 seconds after you push it for the
last time, the dishwasher will automatical-
ly revert to the normal display.
The hardness level setting is saved.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the de-
vice functions perfectly. Carry out this test run
when the dishwasher is empty and without
any dishwasher detergent.
1. Open the valve completely.
2. Close the dishwasher door.
3. Press the button (1) to switch on the
dishwasher.
You will hear a signal tone and all LEDs
will illuminate briefly.
After a moment, the
ECO
programme
LED will light up.
4. Press the
P
button (12) repeatedly until
the LED to the right of the
programme
symbol lights up.
5. Start the programme with the button
(13).
The programme will begin after a few sec-
onds.
6. Ensure that no water comes out and no
unusual sounds are emitted.
7. When the programme is finished, an
acoustic signal will sound.
Switch the dishwasher off using the but-
ton (1).
8. Slightly open the door to allow the moist
air to escape more effectively.
9. Close the valve.
If no water has escaped and no unusual nois-
es have been heard, the dishwasher is ready
for operation and you can now load it with
dishes.
