Page EN-24
Set-up, connection and initial start-up
Connecting the outlet hose
NOTICE
Malfunction!
Failing to connect the appliance cor-
rectly may cause malfunctions during
operation.
■
Make sure that the waste water can
drain freely at any time. To that end,
the outlet pipe must have a minimum
diameter of 40 mm.
■
Ensure that there are no kinks or dam-
age to the outlet hose.
■
Make sure that the end of the hose is
not submerged in the pumped water.
■
Do not extend the outlet hose or re-
place with another drainage pipe.
Ø ≥ 40 mm
max. 1000 mm
You can connect the outlet of the waste water
hose in two different ways:
– Connection to a floor drain.
– Direct connection to the odour seal (si-
phon) of your washing/dishwashing basin.
Specific technical measures are required
for this. For this reason, only plumbing ex-
perts or members of our service team may
connect the outlet hose (see page EN-31).
The outlet hose must be a maximum of
1000 mm above the floor.
Connecting the inlet hose
NOTICE
Risk of damage!
The appliance is designed for a water
pressure of 0.4 to 10 bar (0.04 to 1.00
MPa, 40 to 100 N/cm²). Water must al-
ways be able to run freely into the dish-
washer, otherwise this can damage the
appliance.
■
If the water pressure is higher than
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
■
Never connect the appliance to the
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
■
Ensure that the inlet hose is not
kinked and is carefully connected.
■
Do not cut through the inlet hose.
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist ("Service" see
page EN-31).
■
Do not use old or previously installed
inlet or outlet hoses.
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve’s lock nut to the
tap hand-tight.
Содержание WQP12-J7635E
Страница 70: ......