Hanseatic WQP12-7311D, Техническое и сервисное руководство

Страница: 16 / 37

Washing Pump Theory of parts - >
Check the machine part
1. If the electric part is OK, we need to check the machine part.
2. Remove bottom board.
3. Check the pump assembly, if the bracket is loose, it will bring the noise, we need to
tighten it.
4. If the wash pump cannot start and the machine hasn’t been used too long, maybe the
seal element is bond.
5. If the drain pump is working, but no water out or just a little. We should check the vane
wheel.
Access Washing Pump
1. Disconnect power.
2. Remove bottom board.
3. Label and disconnect the 2 terminals to the motor wire connector.
4. Remove the clamp fastening the interconnect hose to the sump.
Caution: The clamp is easily damaged during removal and can’t be reused. Replace the old
clamp with a new universal clamp.
5. Disconnect the ground wire from the wash pump motor assembly.
6. Remove the motor pump assembly from the dishwasher.
7. Reverse above procedures to install.
Inspect Washing Pump
Check the electric part
1.Open the control panel and take out PCB;
2.With the door closed, unplug the CON5 , then use the
multi-meter
shelf to test resistance between two wires
(ML and ACN), the normal resistance is about 100 to
170 .
3. I f the resistance is not correct, it means the pump coil
is broken or the connector is loose, In this case, we
should check the connection first. If the problem hasn’t
been solved by re-connection, we would replace the
washing pump.
4.If the resistance is OK but it cannot work, it maybe the
capacitor weakly, we need to replace the capacitor.
Ω
Ω
Ω
- 16 -
ML
ACN