Page EN-36
First use
Problem
Possible cause
Solution
The display (8) is illuminat-
ed although dishwasher salt
has been added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using
the end of a spoon or similar.
A peep tone will sound every
minute.
The dishwasher door is not
closed and the programme
has been launched.
Close the dishwasher door.
The water is not running or it
is running only very slowly.
There is a kink in the inlet
hose.
Lay out the inlet hose in such
a manner that it is not kinked.
The water tap is not on
properly.
Turn the water tap on
completely.
The water is not running off or
only very slowly.
The filters are blocked.
Clean the filters
(see page EN-26).
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
Lay out the outlet hose in the
proper manner
(see page EN-29).
The washer is still in the
exhaust manifold.
Replace the washer with a
sealing ring.
The dishwasher is not
watertight.
The door seal is defective.
Have the door seal replaced
by our service team
(see page EN-38).
The outlet hose or the inlet
hose is defective.
Have the defective hose
replaced by our service team
(see page EN-38).
Error code
Solution
E1
: It takes too long for the
water to fill up.
Turn the water tap on completely.
Arrange the inlet hose properly so that it is not kinked
(see „Connect the inlet hose“ on page EN-29).
Ensure that the water pressure is correct
(see „Technical specifications“ on page EN-40).
E3
: The heating element is
defective.
Have the appliance examined and repaired.
E4
: Water overflow.
Switch off the tap. Find the gap in the seal (or have someone
find it) and repair the leak (or have it repaired). If water has
collected in the collection tray at the bottom of the appliance,
empty this before restarting the appliance.
Ed
: Internal error.
Have the appliance examined and repaired.