
Page EN-36
First use
Problem
Possible cause
Solution
A peep tone will sound every
minute.
The water tap is turned off
when the programme is
started.
Turn the water tap on
completely.
The dishwasher door is not
closed and the programme
has been launched.
Close the dishwasher door.
Programme pauses.
Press the button (6).
The water is not running or it
is running only very slowly.
There is a kink in the inlet
hose.
Lay out the inlet hose in such
a manner that it is not kinked.
The water tap is not on
properly.
Turn the water tap on
completely.
The water is not running off or
only very slowly.
The filters are blocked.
Clean the filters
(see page EN-26).
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
Lay out the outlet hose in the
proper manner
(see page EN-28).
The washer is still in the
exhaust manifold.
Replace the washer with a
sealing ring.
The dishwasher is not
watertight.
The door seal is defective.
Have the door seal replaced
(see page EN-38).
The outlet hose or the inlet
hose is defective.
Have the defective hose
replaced (see page EN-38).
The dishwasher can be
switched on/off, but not can-
not be operated.
The dishwasher can only be
operated when the dishwasher
door is closed.
Close the dishwasher door.
Error code
Solution
E1
:
It takes too long for the water
to fill up.
Turn the water tap on completely.
Arrange the inlet hose properly so that it is not kinked
(see “Connecting the inlet hose” on page EN-29).
Ensure that the water pressure is correct. See “Technical spec-
ifications” on page EN-40.
E3
:
Required temperature is not
reached.
Have the appliance examined and repaired.
E4
:
Water overflow.
Switch off the tap. Find the gap in the seal (or have someone find
it) and repair the leak (or have it repaired). If water has collected
in the collection tray at the bottom of the appliance, empty this
before restarting the appliance.