Installation and connection
Page GB-29
Installation and connection
Transport
Your cooker set comes in sturdy packaging
and is so heavy that it should not be carried
by one person alone.
NOTICE
Risk of damage!
■
If a trolley is used to move the cook-
er set, the appliance must be lifted
as shown on the packaging.
Installation
Important user information:
The cooker set has been designed to be installed
in a kitchen unit. If you possess the required
handicraft skills, you can install it yourself.
However, the electrical connection must be
carried out by an authorised professional.
Installation requirements
• The cooker may only be installed
on one
side
next to
higher
kitchen furniture, ap-
pliances or walls.
• The cooker should not be
installed di-
rectly
beside refrigerators or freezers.
Heat loss unnecessarily increases their
energy consumption.
• Keep the oven at least one centimetre
away from the wall. The
cooker pow-
er connection
must therefore be a
flush-mounted box or must be located
outside the installation space.
• The hob and oven are connected by the
permanently installed wiring harness;
they must therefore be installed in
direct
alignment
to each other.
Preparing food
30 – 40
The following conditions must be fulfilled:
– The worktop must be at least
30 to 40
mm
thick and at least
600 mm
deep. It must
also be horizontal and level and must be
sealed on the wall side against overflowing
liquids.
– The hob must be surrounded by
at least
50 mm of
worktop on all sides.
– Veneers, plastic coverings and adhesives
which are used must be resistant to heat
(100°C).
1. Use a jigsaw to cut a hole in the worktop
for the hob. It must have the following di-
mensions.
(Measurements in mm)
560 to 562
490 to 492
min.
50
min.
50
