Page EN-11
Adding dishwasher salt, rinse aid and dishwasher detergent
Adding rinse aid
NOTICE
Risk of damage!
Excessive rinse aid can lead to increased
foaming and can compromise the rins-
ing results.
■
Wipe away rinse aid which has over-
fl owed immediately.
■
Take note of the markings for the
maximum fi ll quantities (“max”) in
the rinse aid chamber.
Using unsuitable substances can cause
damage to the dishwasher.
■
Only put rinse aids which are suita-
ble for dishwashers into the rinse aid
chamber.
As rinse aid is automatically dispensed during
operation, it ensures that the dishes are spot-
free and accelerates the drying process.
Add rinse aid before first use and when the
indicator
(23) lights up.
You do not need rinse aid
– if you are only using multitabs which al-
ready contain rinse aid.
(31)
1. Open the cover of rinse aid dispenser (31).
(31)
2. Fill the water tank to the “max” mark in
the opening.
3. Wipe away any rinse aid which has spilt
immediately so that you don’t compro-
mise the rinsing results and to avoid in-
creased foaming.
4. Close the cover again.
Changing rinse aid setting
We would recommend that you do not change
the dosage that was set by the factory initially.
If the dishes are
– matt and stained after cleaning, increase
the dose.
– sticky and streaky, you should decrease
the dose.
Quickly take the following steps, otherwise
interrupt the process from (see „Water hard-
ness“ on page EN-26).
1. Switch on the appliance with the button
(1).
2. Press and hold the (10) button for 5
seconds within 60 seconds of switching
on the appliance.
3. Push the button (8) to switch to setting
mode.
The signal (23) will flash. The current val-
ue (d1 to d5) illuminates on the display (6).
4. Select the desired dose using the
button (10): from d1 (low) to d5 (high).
5. The appliance will save the setting after
5 seconds, and the display will return to
the original indicator.
