Page EN-31
Set-up, connection, installation and initial start-up
1. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
2. Loosen both screws on the reverse side
of the covering panel and remove them.
(c)
3. Affix the enclosed condensation-protective
film (c) to the bottom of the work surface.
In this way, you will avoid damage to the
work surface caused by hot steam emit-
ting from the dishwasher when the door is
opened.
4. Place the dishwasher in the desired p
osition.
5. In order to equalise unevenness in the
floor and set up the dishwasher on a level
horizontal base, you can screw the four
adjustable feet in or out. There are slots
in the appliance feet around the circum-
ference. Insert a screwdriver and turn the
appliance foot.
Use a spirit level to set up the dishwasher.
