Assembly
Page GB-12
Place the drill holes
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
■
Before drilling the holes, ensure that
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
■
The distance between the cooking
surfaces and the lower edge of the
hood must be at least 65 cm for gas
stoves.
■
For gas stovetops, you must read the
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
stovetop.
2. Draw the five drill holes on the wall, fol-
lowing the upper diagram. Pay attention
to the hole distance and horizontal orien-
tation of the wall brackets.
3. Drill holes at the marked points, using a
diameter that can accommodate the dow-
els.
4. Place the dowels into the holes.
Attaching the Exhaust hood
(5)
(5)
Stifte
1. Place the two halves of the check valve
(5) into the opening on the top of the
Exhaust hood(1).
Make sure that the pins on the valve are
facing outwards.
(8)
(12)
2. Screw the wall bracket (8) for the exhaust
hood into the dowels using three round-
head screws (12).
3. Hook the exhaust hood onto the wall
bracket (8).
