![Hanseatic 28935855 Скачать руководство пользователя страница 79](http://html1.mh-extra.com/html/hanseatic/28935855/28935855_user-manual_594975079.webp)
Installation, connection and initial commissioning
Page EN-35
Setting up the appliance
– The installation site must be frost-proof.
– A water connection as well as a bath or
sink must be available.
– The mains plug must also be easily acces-
sible once the appliance has been set up.
– The ground must be secure, even, clean
and dry.
– It is not appropriate to have a rug or car-
pet under the appliance, as the appliance
will not be ventilated well enough and can
overheat.
– For use on rugs, carpets, parquet or wood-
en floorboards, place a stable wooden
board (measuring at least 60 × 60 cm) un-
derneath the appliance.
– If it is placed on a wooden plate or base,
the screw-on feet should be fixed so that
the appliance does not dislodge itself when
spinning.
– Lay a smooth tiled floor or rubber mat un-
der the screw-on feet.
Aligning the appliance
(33)
(17)
1. Loosen the lock nut (33) of one of the
screw-on feet (17) underneath the appli-
ance.
2. Using your hand, screw the foot (17) in
or out as far as necessary. To adjust the
foot, twist it
– anti-clockwise to unscrew.
– clockwise to screw in.
3. Repeat this for the other screw-on feet
until the appliance is standing completely
horizontally and securely.
4. Twist the lock nuts of all screw-on feet
upwards to the underside of the machine
and tighten the lock nut against the un-
derside of the machine.
Connection
Establish drain for water
WARNING!
Risk of scalding!
Improper handling of the appliance
can lead to scalding caused by hot suds.
■
Fix the hose to the sink or bath to pre-
vent it from slipping due to the recoil
caused by pumping.
■
For drains, make sure that the cross
section of the discharge pipe is great
enough that the drain cannot over-
fl ow.
NOTICE
Risk of damage to property!
Improper handling of the appliance
can lead to water damage.
■
Use only the water outlet hose pro-
vided.
■
Do not extend the water outlet hose
or replace it with another hose.
■
The water outlet hose must not get
bent or twisted.
■
The bend on the water outlet hose
should be no more than 100 cm
above the ground to ensure that wa-
ter can be drained off properly.
■
The water outlet hose must be in the
retaining clips on the back of the ap-
pliance so that the bend on the hose
always remains above the waterline
inside the appliance. The end of the
hose must not be submerged in the
pumped water.
You can fit the outlet hose in two ways: