Page EN-28
Troubleshooting table
Problem
Possible cause
Solution
The LED (9)
is illuminated
although dish-
washer salt has
been added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the end of a
spoon or similar.
The water is
not running or it
is running only
very slowly.
There is a kink in the inlet
hose.
Arrange the inlet hose properly, avoiding
kinks (see „Connecting the inlet hose“ on
page EN-25).
The water tap is not properly
on.
Turn the water tap on completely.
The water is not
running off or
only very slowly.
The filters are blocked.
Clean the filters (see „Cleaning the filters“
on page EN-22).
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
Lay out the outlet hose in the proper man-
ner (see „Having the outlet hose connect-
ed“ on page EN-25).
The dishwasher
is not watertight.
The door seal is defective.
Have the door seal replaced (see „Service
department“ on page EN-30).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced (see
„Service department“ on page EN-30).
The dishwasher
can be switched
on/off, but not
cannot be oper-
ated.
The dishwasher can only be
operated when the door is
closed.
Close the door.
The dishwashing results are not satisfactory
Problem
Possible cause
Solution
There are resi-
dues or streaks
on the dishes.
The rinse aid is incorrectly
dosed.
Adjust the dispensed dose (see „Adding
rinse aid“ on page EN-12).
There is no dishwasher salt.
Add dishwasher salt (see „Adding dish-
washer salt“ on page EN-13).
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the end of a
spoon or similar.
