Page EN-35
Installation, connection and initial commissioning
(38)
5. Remove the protective films from the side
end profiles (38).
6. Affix the end profiles to the left and right
front edges of the dishwasher. This will
prevent a crack being visible between the
appliance and the adjacent kitchen cup-
boards.
7. Slide the appliance into the recess.
Aligning the appliance
To position the dishwasher so that it is level,
the two front adjustable feet (32) and the back
foot on the appliance can be adjusted by up
to 50 mm.
The front adjustable feet are equipped with
slots.
You can adjust the height of the rear adjusta-
ble foot with the centre adjusting screw.
UP
DOWN
(32)
1. Insert a screwdriver into one of the slots
and turn the adjustable feet to the height
required.
2. Use a cross-headed screwdriver to set up
the front adjustable feet.
3. Check the alignment with a spirit level.
4. Make sure that the top edge of the ap-
pliance is up to the bottom edge of the
worktop to prevent it from tipping forward
when you open the appliance door.
Screw the dishwasher to the
kitchen units
(40)
(44)
(39)(43)
If you have granite worktops:
1. If you have granite worktops, remove the
internal side cover caps (39), and screw
the appliance to the adjacent kitchen cup-
boards.