Hanseatic 2013C(G)3.334eETsDpHbX, Руководство пользователя

Страница: 74 / 84

Page EN-32 Fitting and installation
L1 – L3: Phase(s)
N: Neutral conductor
PE: Protective conductor (earth
wire)
230 V 1N~ / 50 Hz
L1
N
PE
3
2
1 4
5
L1 to
  
(bridged)
N to
 
(bridged)
Protective conductor (PE) to
Conductor cross-section: 3 x
6 mm
2
400 V 2N~ / 50 Hz
L2
L1
N
PE
3
2
1 4
5
L1 to

L2 to
 
(bridged)
N to
 
(bridged)
Protective conductor (PE) to
Conductor cross-section: 4 x
2.5 mm2
400 V 3N~ / 50 Hz
L2
L3
L1
N
PE
3
2
1 4
5
L1 to

, L2 to

,
L3 to

N to

(bridged)
Protective conductor (PE) to
Conductor cross-section: 5 x
2.5 mm2
Inserting the oven
NOTICE
Risk of damage!
■
Do not use the oven door handle to
lift the entire oven! It is not designed
to bear the weight of the cooker. Use
the carrying handles on the sides.
■
Do not set the oven down on the edge
or corner of the oven door! The glass
panes can be damaged.
The following conditions must be fulfi lled:
– The dimensions of the recess must be 600
× 560 × 560 mm (H × W × D).
– The built-in cabinet can be equipped with
either ledges/rails or an intermediate shelf
with a ventilation cut-out.
– An intermediate shelf is required if a draw-
er is to be installed below the oven.
– Veneers, plastic coverings and adhesives
which are used must be resistant to heat
(100°C).
1. Sweep or vacuum out any residual wood
shavings.
2. Slide the oven into the built-in cabinet as
far as possible using the carrying han-
dles, in order that the earthing screw and
the connector jack are both easily acces-
sible for the hob.
3. Insert the hob plug into the socket on the
top of the cooker. The plug is coded. Po-
larity reversal is therefore not possible.