background image

+

Your Hearing System. 

Operating Element.

Replacing the Battery. 

Turning Your Hearing Systems on and off.

0124

Conformity to directive 

93/42/EEC concerning 

medical devices 

Low Battery Warning 

Two long beeps indicate the hearing system battery is 

low. After the low battery warning, sounds may not be 

as clear. This is normal and can be fixed by changing 

the batteries in the hearing systems. 

If you are not able to hear the low battery warning, 

your hearing system professional can change its pitch 

or loudness. If you prefer, it can be turned off entirely.

Battery type:

  Open the battery door.

  Close the battery door.

  Insert the battery into the battery 

compartment, so that the 

negative pole

  

faces into the door.

With a new battery, it may take a few 

minutes for the battery to develop its full 

output. Only then should you close the 

battery door.

!

1. On:

 

• 

Close the battery door fully.

Note: It may take 5 seconds before the 

hearing system turns on. Your hearing healthcare 

provider can increase the start up delay if 

required.

3. Open: 

• 

Fully open the battery door to access and 

change the battery.

Note: To switch the hearing system on 

your ear on or off, hold the device between your 

thumb and forefinger.

Open and close the battery compartment with 

the forefinger of your other hand. Use the index 

finger of your opposite hand to open and close 

the battery door.

2. Off: 

• 

Partially open the battery door.

With Remote Control

  Refer to the remote control user guide.

  Refer to the remote control user guide.

With Remote Control

If the pushbutton has been configured as a volume control, you can 

adjust the volume level by pushing the + or – button.

Push the button on your right hearing system to increase the volume 

in both hearing systems.

Push the button on your left hearing system to decrease the volume 

in both hearing systems.

As you change the volume, your hearing systems will beep.

With Pushbutton

With Lever

  If the lever has been configured as a volume control, you can adjust 

the volume of your hearing systems.  

Press up to increase; press down to decrease. As you change the 

volume level, your hearing systems will beep.

Volume setting

Suggested volume level

Turning volume up

Turning volume down

Maximum volume level

Minimum volume level

Beeps

 

1 beep

 

short beep

 

short beep

 

2 beeps

 

2 beeps

Adjusting Volume.

1

 Earhook

2

  Microphone / Microphone shield

 

3

   Push button 

– switches between listening programs and/or 

changes the volume level (depending on individual fitting)

3a 

Wippe

 – switches between listening programs and/or changes the 

volume level (depending on individual fitting)

4

   Battery door

5

   Dome (Olive)

  

6

   Retention piece

 – helps prevent the dome and wire from moving 

out of the ear canal

7

   Slim tube

 (

mini tube

)

7a

  Sound tube 

 

part of the earmold that attaches it to the earhook

 Earmold

Which System Goes in Which Ear:

Red = right ear     Blue = left ear 

Option: Slim tube 

(

with mini tube)

  Refer to the remote control user guide.

Option: Remote control

Hearing System: 

FCC ID:  

beat VMY-UWBTE2 

With Push-

button

Program change

Volume control:  

right device - louder, left device - quieter

With Lever

The lever on your hearing systems can be

set up as a volume control.

quieter

louder

flow 312M

flow 675 UP

beat 675 UP

1

7a

2

2

3a

3a

3

3

4

4

7

5

7a

7a

1

8

8

2
3
2

4

7

6
5

7a

1

8

8

flow 13 SP

beat 13 SP

312

13

675

Instructions For Use

EN

See also ”General Warnings and  

Safety Instructions“, Page 11-20

beat

flow

13 SP

675 UP

312 M

13 SP

675 UP

GA beat_flow_99157_560x140_EN.indd   1

26.05.16   13:52

Отзывы: