Hansa C13 O&M Manual - OM-007 Revision L 28/06/2021
© Hansa Chippers 2020
19
Once the tension is set, use two 24 mm spanners to screw the
two M16 adjustment nuts downwards until they touch the
adjustment block. Then turn the top nut clockwise and the
bottom nut anti clockwise simultaneously to lock the nuts in
place.
Belt replacement
If the belts in your chipper look similar to any of the following images or are clearly broken, then they need to be replaced.
If a belt change is necessary, follow these steps
Using a 6 mm Allen key, unbolt and remove the pulley
guard (5 x M8 bolts).
Note
: Engine not shown in this view.
Using two 17 mm spanners, unbolt and remove the engine
(4 x M10 nuts).
Note
: Loosen the belt tensioner to allow room for removal.
3
1
2
Cracked underside of belt
Sidewall belt wear
Soft, swollen belt
Worn cover on back of belt
Split belt cover
Adjustment
nuts
Adjustment
block
