
4
Assembly (see page 32)
English
Safety Notes
Gloves should be worn during installation to
prevent crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.
Installation Instructions
• Prior to installation, inspect the product for
transport damages. After it has been installed, no
transport or surface damage will be honoured.
• The pipes and the fixture must be installed,
flushed and tested as per the applicable
standards.
• The plumbing codes applicable in the respective
countries must be observed.
• 72831000 / 72832000: The mixer can not
used together with a continuous flow water
heater.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 70°C
Recommended hot water temp.:
65°C
Thermal disinfection:
max. 70°C / 4 min
The product is exclusively designed for drinking
water!
Symbol description
Do not use silicone containing acetic acid!
Adjustment
(see page 34)
To adjust the hot water limiter. Using a hot water
limiter in combination with a continuous flow water
heater is not recommended.
Dimensions
(see page 37)
Flow diagram
(see page 38)
Spare parts
(see page 39)
Special accessories
(order as an extra)
• Adapter (G⅜ / G½) #93395000
(see page 41)
Cleaning
(see page 43)
Maintenance
(see page 44)
The check valves must be checked regularly
according to DIN EN 1717 in accordance with
national or regional regulations (at least once a
year).
Operation
(see page 35)
• Hansgrohe recommends not to use as drinking
water the first half liter of water drawn in the
morning or after a prolonged period of non-use.
• Minor leaking may occur briefly at the spout
when opening the fitting via the lever.
Test certificate
(see page 36)
Fault
Cause
Remedy
Mixer stiff
- Cartridge defective, calcified
- Exchange cartridge
Mixer dripping
- Cartridge defective
- Exchange cartridge
Water escaping at the threaded
base
- connection hoses not completely
screwed into basic body
- Tighten connection hoses by
hand
- O-ring at the connection hose
defective.
- Exchange O-ring
Hot water temperature too low
- Hot water limiter incorrectly set
- Set hot water limiter