Hans Grohe Mediano 14912000, Быстрый старт

Страница: 6 / 12

English
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the rubber sealing
washer in position on the sink.
3. Slip the slide washer, washer and collar nut over
the threaded base and tighten the collar nut by
hand. Tighten screws.
4. If necessary shorten platic hose according to the
table and insert it up to the collar into the
shorter blue marked copper pipe.
5. Connect the shorter, blue marked supply pipe to
the angle valve.
Connect the longer blue marked pipe to the
inlet and the red marked to the outlet of the
storage tank.
Attention! *
With water heaters of 5 liters the flow rate at the
mixer should not exceed 5 l/min.
In this case the flow rate must be reduced at the
angle valve.
Operation
The mixer is actuated by lifting the lever head.
Swivel to the left = hot water,
swivel to the right = cold water.
When the storage tank is being heated, the spout
will drip.
When changing the spray former, it is imperative to
use one made for this type of mixer.
Technical Data
Operating pressure: max. 10 bars
Recommended operating pressure: 1 - 5 bars
Test pressure: 16 bars
Hot water temperature: max. 80° C
Recommended hot water temp.: 65° C
Rate of flow with water heaters
of 5 liters:
max. 5 l/min
Spare parts
1 handle
1.1 screw cover basin
94186000
2 flange 95046000
3 nut 94106000
4 cartridge cpl. 14097000
5 seals 13967000
6 service set 13953000
7 mixer ball 13966000
8 spray former 94033000
9 washer 94850000
10 fixation cpl. 13961000
fixation extension 35 mm 13898000
1 - 1,5
2 - 3
4 - 7
Hose lengths to be used
storage tank volume max. permissible water
pressure on the spot
in bars
without hose hose to be shortened to 90 mm
hose to be short
ened to 90 mm
hose unchanged
8, 10 and 15 liters
up to 5 liters
hose unchanged,
reduce flow rate at the angle valve*
If pressure greater than 5 bar, fit pressure reducer.