16
Trouble Shooting
Fault
Cause
Remedy
Insuffient water flow
- Supply pressure inadequate
- Shower filter seal dirty
- Thermostat cartridge filters dirty
- Check mains pressure
- Clean filter seal between
shower and hose
- Remove cartridge & clean the
filters on the barrel
,Crossflow‘, hot water is forced
into cold water pipe, or vice
versa
- check valves dirty or leaking
- Clean check valves -
replace if necessary
Spout temperature does not corre-
spond wlth the temperature set
- Thermostat has not been
adjusted
- Hot water temperature too low
- Calibrate thermostat
- Increase hot water temperature
No temperature control
- Thermostat cartridge failure or
blocked filters
- Check/clean filters
- Replace cartridge
Shower or spout dripping
- Dirt in the flow valve or ‚shut
off‘ unit damaged
- Clean or replace shut-off unit
Warranty
You have purchased a quality product from Hansgrohe. All parts which show any kind of fault as far as
construction, material or assembly are concerned within the first 24 months after installation, we will repair
or exchange the part in question free of charge. Faulty items become our property.
We do not grant warranty for faults caused by:
unsuitable or improper use; incorrect assembly; installation started and/or completed by a non-qualified
plumber, natural wear out, improper or careless treatment, lack of maintenance; unsuitable usage;
chemical, electro-chemical or electrical influences.
Hansgrohe · Postfach 1145 · D-77761 Schiltach · T49 (0) 78 36/51-1282 · T49 (0) 7836/511440
E-Mail: [email protected] · Internet: www.hansgrohe.com
10/2011 9.04190.03
Technical Hotline
0 870 7701975
