Hans Grohe AXOR Starck 10101 1 Series, Инструкция по установке / Руководство пользователя / Гарантия, Страница: 2 / 28

2
E N G L I S H
TECHNICAL INFORMATION
Water pressure
Recommended 15 - 75 PSI (0.1 - 0.5 MPa)
Maximum 145 PSI (1 MPa)
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum 158°F (70° C)*
Max. flow rate 1.5 GPM (5.7 L/min)
0.25 gallons (0.95 liter) per cycle**
Hole size in mounting surface 1⅜" (35 mm)
Max. depth of mounting surface 1⅝" (40 mm)
Battery CR-P2 / 6 V Lithium
Automatic shutoff after 10 seconds***
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
** 10 second maximum cycle time
*** This is the maximum amount of time the faucet will run
while a hand is within range of the sensor.
INSTALL ATION CONSIDERATIONS
⁄ For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
⁄ Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
⁄ Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
⁄ Flush the hot and cold supplies thoroughly before
installing the faucet. Damage to the faucet caused
by debris is not covered under the warranty.
⁄ The hot and cold supplies should be of equal
pressure.
⁄ The faucet should not be used with a continuous flow
water heater.
⁄ Do not install the faucet on a sink with a raised edge.
⁄ Strong light sources should not shine directly on the
sensor window of the faucet.
⁄ The faucet should only be used with the battery pack
supplied by Hansgrohe. Do not attempt to use any
other battery pack.
⁄ The faucet incorporates automatic range adjustment
-- the sensor automatically adjusts itself to local condi-
tions (lavatory, brightness, etc.)
⁄ The distance between the switch on/off point to the
faucet is approx. 6¼" - 8" under normal conditions.
The detection area may be less for dark, non-reflec-
tive objects, or greater for bright, highly reflective
objects.
If the sink is ver y small or highly reflec-
tive, follow the range reduction instruc-
tions. When the faucet is in reduced
range mode, the LED in the sensor
window will flash while the faucet is not
in use.
⁄ Drops of water or condensation on the sensor win-
dow may cause the faucet to run.
The spray pattern will be unattractive
immediately af ter installation or ser vice,
due to air in the faucet. Af ter the faucet
is used 10 - 15 times, the spray pattern
will clear.
⁄ At the start of operation, or after maintenance, func-
tion of the faucet may be delayed due to reflections
during adjustment of the operating distance. The
faucet will automatically calibrate itself. The self-
calibration will start after 10-15 minutes.
Hansgrohe recommends not to use as drinking wa-
ter the first half liter (approximately 1 pint) flowing
from the faucet in the morning, or after prolonged
non-use.