8
English
Assembly
Attention!
The fitting must be installed, flushed and tested
after the valid norms.
1. Flush through the supply pipes.
2. Mount the S - unions and align them.
3. Fasten the mixer with the washers.
The hot and cold water supply’s should be of equal
pressures.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0.1 - 0.5 MPa
Test pressure:
1.6 MPa
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
max. 80° C
Recommended hot water temp.:
65° C
Centre distance:
150 ± 16 mm
Connections G ½”:
cold right - hot left
Rate of flow:
approx. 26 l/min
Anti-pollution function
To adjust the hot water limiter on single lever mixers,
please see page 15.
No adjustment is necessary when using a continuous flow
water heater.
Hansgrohe single lever mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0.15 MPa.
Attention!
The non return valves must be checked regularly according
to DIN EN 1717 in accordance with national or regional
regulations (at least once a year).
Spare parts
(see page 3)
1 handle
34094000
1.1 screw cover
96762000
2 flange
96763000
3 nut
97209000
4 cartridge cpl.
92730000
5 flange
96467000
6 S-unions
96742000
7 aerator cpl.
97356000
8 selector assy
94077000
9 diverter knob
97355000
10 non return valve DW 15
94074000
11 noise reduction
96429000
Fault
Cause
Remedy
Insufficient water
- Shower filter seal dirty
- Non return valve hasn’t moved back
- Clean filter seal between shower
and hose
- Exchange non return valves
Mixer stiff
- Cartridge defective, calcified
- Exchange cartridge
Mixer dripping
- Cartridge defective
- Exchange cartridge
Hot water temperature too low
- Hot water limiter incorrectly set
- Set hot water limiter
Instantaneous heater didn’t work
- Flow limiter in handshower isn’t re-
moved
- Filter are dirty
- Non return valve didn’t move back
- Remove flow limiter
- Clean the filter / exchange filter
- Exchange non return valves
