6
.3.3: Full Automatic Radio Station Storage: In the radio broadcast mode, press and hold [ ] for 2 seconds to initiate a full
automatic scan for radio stations. The device will automatically store stations from the lowest to the highest frequency point.
During the full automatic scanning process, the LCD will display "SCAN" in the upper left corner and the station's address
number in the upper right corner as "M**" (the number represents the station's address number). After completing one round
of scanning, the device will automatically stop the search and start playing the first stored station.
*This device can store up to 20 AM stations, 30 FM stations, and 60 SW stations, for a total of 110 radio stations.
Note: The number of stored radio stations may vary based on the local signal strength and environment.
6.4: Manual Station Storage Method:
In the radio broadcast mode, after using the methods described in 6.3.1 & 6.3.2 to search for your desired station frequency,
do the following: Light press [ ] to enter the station storage mode. The LCD will display the station address as " M **,"
with the "**" station address number flashing. At this point, press [
▲
or
▼
] to select the station address number. Press [ ]
again to confirm your selection, and the "**" station address will stop flashing. After 5 seconds, the " M**" station address
display will exit, indicating that the manual station storage operation is complete.
6.5: Method for Removing Radio Station
In the radio broadcast mode, after storing radio stations using the methods described in sections 6.3.3 and 6.4, light press [
▲
&
▼
] to select station numbers. Each light press of [
▲
or
▼
] will change to the next stored radio station.
Note: If the LCD displays 'M **----,' it means there are no preset radio stations.
7: Bluetooth Playback:
7.1 The Bluetooth pairing name for this product is: HRD-206.
7.2 In the power-on working mode, light press [ ] to switch to the " " mode. The " " symbol will blink, indicating
that it's waiting to connect to a Bluetooth device. Once the connection is successful, the " " symbol will stop
blinking.
7.3 Light press [
▲
] to skip to the next song, light press [
▼
] to go back to the previous song, and light press [ ] to toggle
between pause and play. You can also use your mobile device for corresponding controls.
8: Using TF Card/USB Card Playback
Properly insert the TF card. Properly insert the USB playback card.
8.1: Turn the switch [ ] to the TF position, light press [
] to switch to " " card mode/USB mode, and music
will play automatically. Light press [ ] to pause/play.
8.2: Light press [
▲
] to skip to the next song, light press [
▼
] to go back to the previous song, long press [
▲
] for fast-forward,
and long press [
▼
] for fast rewind down
8.3: Supports a maximum of 256GB.
8.4: Supports MP3, WMA, WAV, APE, and FLAC formats for music playback.
9: Time Settings
In the power-on or power-off mode, long press [ ] for 2 seconds to initiate the runtime setting. The hours "**" will start
flashing as a prompt. Light press or long press [
▲
,
▼
] to adjust the hour time upwards or downwards. Then, light press [ ]
to move to the minute time, which will also start flashing. Light press or long press [
▲
,
▼
] to adjust the minute time