LIGHTING INSTRUCTIONS
Warning: If these instructions are not followed exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
1. Make sure the control knob is in the "OFF" position. See Figure 15 Open the tank
valve all the way.
2. Push in the igniter button. You will hear a slight clicking sound. With the igniter button
pushed in, push and turn the control knob to the “ON” position. the fire should light within a
few seconds. Once the flame is lit, release the igniter button and continue to hold the
control knob in for 10 to 15 seconds. Release the control knob. The control knob should
pop back out and then remain lit.
Note: If the fire does not light, turn the knob to the “OFF” position and wait five (5) minutes
before trying again.
3. To turn down the flame, push the control knob in slightly and turn to Medium (medium
or Low (small flame).
4. To shut down the fire pit, turn the control knob to the “OFF” position and turn off the tank
valve.
MAINTENANCE
The flames should look like those in Figure 16. To clean the
burner, use a soft brush after the burner has cooled
completely. Never use a vacuum cleaner on the burner. It is
recommended that the fire pit be stored indoors during the
winter if it will be subjected to freezing temperatures. The LP
cylinder must be disconnected and removed from the
appliance before the appliance can be stored indoors.
Figure 16
IGNITER BUTTON
CONTROL KNOB
Figure 15
