Page 4
ASSEMBLY INSTRUCTIONS
1
2
Place the table
upside down on a flat, non-abrasive surface. Attach
table leg to the table
rim by using the bolt and washer as shown in
. Guide the bolt through the hole in the table leg, into
the pre-drilled hole in the table rim.
Repeat for the other three legs.
rim (without glass)
a
Fig 1
Hand tighten only 2-3 turns.
.
Attach a leg to the leg connector bracket by carefully guiding the bolts already in place on the table legs (each
leg has two bolts) through the holes in the leg connector bracket. Add a washer and a nut to the end of each
bolt as shown in
.
Repeat on the other three legs.
Fig 2 Hand tighten only 2-3 turns.
.
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex wrench to tighten
all bolts .
each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to all bolt
joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are tight.
Over tightening may strip bolts. Cover all bolts with covers.
Note:
Do not over tighten.
B
FOOT CAP
E
G
H
C
F
G
I
D
4
With the help of another person, turn the table in the upright position. Note the clear bumpers spaced evenly throughout
the inside of the rim. Carefully place table glass inside the rim, resting on the clear bumpers.
