Page 4
ASSEMBLY INSTRUCTIONS
1
2
Place the table top upside down on a flat, non-abrasive surface. Attach the table leg to the table top by using
the bolts and washers as shown in
. Guide the bolts through the holes in the table leg, into the pre-drilled
holes in the table top.
Repeat for the other three legs.
.
Fig 1
Hand tighten only.
Attach a leg to the leg connector bracket by carefully guiding the bolts already in place on the table legs (each
leg has two bolts) through the holes in the leg connector bracket. Add a washer and a nut to the end of each bolt
as shown in
.
Repeat on the other three legs.
.
Fig 2 Hand tighten only.
A
C
FOOT CAP
D
F
G
B
E
F
H
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex wrench to tighten
all bolts .
each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to all bolt
joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are tight.
Over tightening may strip bolts. Cover all bolts with covers.
Note:
Do not over tighten.
