13. Remove the cardboard cover from the ignition well as shown in Figure 12. Remove
any lava rock or fire ice on top of ignition well.
Cardboard Cover
14. Open the tank valve. Apply a solution of soapy water to the tank-regulator connection
and to the valve-hose connection to check for leaks as shown in Figure 13. If soap
bubbles continue to form, the connection has a leak. If a leak is found, close the tank valve
and tighten all connections.
NOTE: NEVER USE A FLAME TO CHECK FOR LEAKS.
BATTERIES
Make sure the control knob is in the "OFF" position.
Unscrew the push button cap on the ignition module located
on the control panel to access the battery compartment. The
ignition module requires one Alkaline AAA size battery
(1.5V). The negative (-) end goes in first. See Figure 14.
Dispose of battery safely. May explode or leak if charged or
disposed of in fire. Make sure of the polarity. Mercury and
cadmium free.
Figure 14
Figure 12
Checking the tank-regulator for leaks
Figure 13
