2.
Disconnect the gas tube from the orifice and remove the orifice holder as shown in Fig .7.
Figure 7
3.
Replace the propane orifice (See Fig.
8
) with the natural gas orifice from the kit and reinstall the
orifice holder by tightening the nuts as shown in Fig. 9. Reconnect and tighten the gas tube to the
orifice.
Figure
8
Figure 9
Apply a solution of soapy water to all connections to check for leaks. If soap bubbles continue to
form, the connection has a leak. If a leak is found, close the tank valve and tighten all connections.
NEVER USE A FLAME TO CHECK FOR LEAKS.
4.
Stick the conversion label on the rating plate as shown in Fig. 10.
Metal Rating Plate
Conversion Label
Figure 1
0
Conversion Label
7
Serial Number _________________
Model Number: 98910
CAUTION:
The gas pressure regulator provided with this appliance must be used. This regulator is set for an outlet pressure of
11 inches water column.
(2.7 kPa).
The gas supply must be turned off at the LP-gas supply cylinder when this
appliance is not in use.
Gas: Propane Input: 40,000Btu/hr
Minimum clearance from combustible constructions: Sides: 24 in.609 mm. Top 72 in. 1828 mm.
FOR OUTDOOR USE ONLY.
If stored indoors, detach and leave cylinder outdoors.
This appliance has been converted to use Natural Gas. Input 40,000 Btu/hr.
Max Gas Supply Pressure 7 inch w.c. (12.2 kPa) Min. Gas Supply Pressure 5 inch w.c. (1.24 kPa)
