G
I
H
I
C
ASSEMBLY INSTRUCTIONS
3
4
F
Attach the front panel to the bottom panel by using four 1/4"x35 mm bolts and washers as shown in
.
Attach the front panel to the side panels by using two 1/4"x20 mm bolts and washers
as shown in
.
F
3
F
3
Hand tighten only.
Hand tighten only.
igure
igure
After making any necessary adjustments to the alignment of the all parts, use the hex bolt driver to tighten
all bolts.
each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to
all bolt joints, we recommend working in a cross corner (X) fashion. Repeat until all bolts are tight.
. Over tightening may strip bolts.
Note:
Do not
over tighten
Attach a hydrolic lid support to the op panel with side panel as shown in
.
Repeat
for other hydrolic lid support.
t
Hand tighten only.
F
4
igure
5
