Page 4
ASSEMBLY INSTRUCTIONS
1
4
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex
wrench to tighten all bolts and nuts. Repeat until all bolts are tight.
Over tightening
may strip bolts. Cover all bolts and nuts with covers. With the help of another person, turn the table in the
upright position.
Do not over tighten.
F
1
igure
Attach a table leg to the leg connector bracket-1 & -2 by carefully guiding the bolts already in place on
the table legs (each leg has four bolts) through the holes in the leg connector brackets. Add a washer
and a nut to the end of each bolt as shown in the
.
Repeat on the
other three legs.
F
1
Hand tighten 2-3 turns only.
igure
3
Place the table top upside down on a flat, non-abrasive surface. Attach the complete base to the table
top by using ten bolts and washers as shown in
.
F
3
Hand tighten 2-3 turns only.
igure
B
2
E
D
C
H
G
J
Figure 2
H
F
I
Attach a middle leg to the leg connector bracket-1 & -2 by carefully guiding the bolts already in place on
the middle legs (each leg has four bolts) through the holes in the leg connector brackets. Add a washer and
a nut to the end of each bolt as shown in the
.
Repeat on the
other three legs.
F
1
Hand tighten 2-3 turns only.
igure
H
G
J
H
F
I
Figure 3
A
