Page 4
ASSEMBLY INSTRUCTIONS
B
FOOT CAP
A
SWIVEL PLATE
1
Position the swivel base on a flat, solid surface. Make sure the swivel plate is positioned all the
way into the base. It may have vibrated out during shipment. The two sets of holes in the swivel
plate should be facing away from you.
Note the arrows on both the swivel plate and the "U" bar portion of the chair frame. Position the
chair frame onto the swivel plate so that the two pairs of holes in the "U" bar are exactly aligned
with the two pairs of holes in the swivel plate and the arrows on both the "U" bar and swivel plate
are pointing in the same direction. Proper positioning of the chair frame on the swivel
plate/swivel base assembly, and proper alignment of the holes in the "U" bar with the holes in
the swivel plate are critical to the safe, well balanced swiveling motion of the chair.
Carefully examine the diagram. Attach a metal plate to two (2) bolts and guide the bolts through
the top of one set of holes in the "U" bar (located at the bottom of the chair frame) and into the
pair of holes in the swivel plate. From beneath the swivel plate, add a washer, then a spring
washer, and a nut to the end each bolt. Hand tighten 3-4 revolutions only. Do not tighten
completely. Repeat this procedure for the pair of holes on the opposite side.
Using the hex wrenches provided, tighten the nuts and bolts. Be sure the bolts are fully
tightened. Remove the arrow labels from the “U” bar and swivel plate.
Cover all bolts with bolt
covers.
2
3
H
C
D
F
E
G
