Safety Instructions
FHTS80073A
7
ANSI Z223.1/NFPA54, or CAN/CGA-B149.1, Natural Gas and Propane Installation Code.
• LP gas tank must be arranged for vapour withdrawal.
• The LP gas tank must have a listed overfilling prevention device (OPD) and a QCCI Type I
(CGA810) LP gas tank connection.
• The LP gas tank must have a tank collar to protect the tank valve.
• Never use an LP gas tank with a damaged body, valve, collar, or footing. Dented or rusted LP gas
tanks may be hazardous.
• The LP gas tank should not be dropped or handled roughly.
• Tanks must be stored outdoors out of the reach of children. Do NOT store in a building, garage,
or any other enclosed area.
• Never store your LP gas tank where temperatures can reach over 125°F (52°C).
• Do not store the LP gas cylinder in direct sunlight or near a source of heat or combustion.
• Never keep a filled LP gas tank in a hot car or car trunk. Heat will cause the gas pressure to
increase, which may open the relief valve and allow gas to escape.
• Place dust cap on valve outlet whenever the LP gas tank is not in use. Only install the
recommended type of dust cap on the LP gas tank and the LP gas tank valve. Other types of
caps or plugs may result in leakage of propane.
a. Do not store a spare LP gas cylinder under or near this appliance.
b. Never fill the LP gas cylinder beyond 80% full.
c. If the information in (a) and (b) is not followed exactly, a fire causing death or serious
injury may occur.
• LP gas cylinders should be filled only by a certified LP gas dealer.
• The pressure regulator is set for 11” W.C. (2.74 kPa).
• The maximum inlet propane gas pressure for this outdoor fire table is 250 PSI; the minimun inlet
propane gas pressure for this outdoor fire table is 25 PSI.
• Never attempt to attach this appliance to the self-contained LP gas system of a camper trailer,
motor home or house.
• Always use the pressure regulator and hose assembly provided with the appliance to connect to
a LP gas cylinder. Never connect to an unregulated LP gas supply. For technical support contact
the service center at 1-866-988-3300.
• Hand turn the manual gas control valve. Never use tools. If the valve will not turn by hand, do not
try to repair it. Call a certified gas technician. The use of force or any self-attempted repair may
result in a fire or explosion.
When connecting your gas cylinder:
Before connecting, be sure that there is no debris caught in the head of the gas cylinder, head of
the regulator valve or in the ports. Connect regulator valve and hand-tighten firmly. Disconnect
the propane cylinder from the regulator valve when the fire table is not in use. DO NOT obstruct
the flow of combustion air and ventilation air to the burner.
1. This fire table comes equipped with a standard LP gas hose and regulator including the
appliance side connection for a CGA No 791 Cylinder Connection Device. The LP gas hose
and regulator supplied with this fire table must be used. Only a hose and regulator specified by
manufacturer can be used for replacement.
HOSE & REGULATOR ASSEMBLY & REPLACEMENT