Page 4
ASSEMBLY INSTRUCTIONS
1
2
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver to tighten
all bolts. Repeat until all bolts are tight.
Over tightening may strip bolts. With the
help of another person, turn the table in the upright position.
Do not over tighten.
F
1
igure
Figure 2
B
C
Place the table top upside down on a flat, non-abrasive surface. Attach the completed base to the table
top by using the sixteen bolts as shown in the
. Guide the bolts through the holes in the table leg,
into the pre-drilled holes in the table top.
F
2
Hand tighten 2-3 turns only.
igure
E
D
F
A
D
Attach a table leg to the leg connector bracket by using a bolt and washer as shown in the
.
Guide the bolt through the hole in the leg connector bracket, into the pre-drilled holes in the table leg.
Repeat for the other three legs.
F
1
Hand tighten 2-3 turns only.
igure
