5. Put the door onto the "L" connector (pre-assembled), guide the pin on the lower "L"
connector into the hole under the door. Then guide the pin on the upper "L" connector
into the hole in the upper portion of the door. Use a 1/4"x15 mm bolt and washer to
secure the "L" connector to the right side panel as shown in Figure 5.
Do not over
tighten.
Figure 5
6. With the help of another person, carefully place the table top onto the table base.
After making any necessary adjustments to the alignment of the table top and the
assembled base, use four
1/4"x15 mm bolts and washers as shown in Figure 6. Guide
the bolts through the holes under the table top, into the pre-drilled holes in the side
panels.
Do not tighten completely.
Figure 6
7. Attach the LP support to door panel by using four 1/4"x15 mm bolts and washers as
shown in Figure 7.
Do not over tighten.
Figure 7
