17)
Ventilation – Slots and openings in the cabinet are provided for ventilation and to ensure
reliable operation of the product and to protect it from overheating, and these openings must
not be blocked or covered. The openings should never be blocked by placing the product on
a bed,
sofa, rug, or other similar surface. This product should not be placed in a built-in installation
such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s
instructions have been adhered to.
17)
The MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
device shall remain readily operable.
18)
回
: CLASS II apparatus with double insulation, and no protective earth provided.
Note :
1.
Important safety instructions shall be provided with each appliance. These safety instructions
may be in the form of a separate booklet, separate sheet, or part of the instruction manual.
2.
If being included in the instruction manual, the safety instructions shall be located before any
operating instructions.
3.
These instructions shall be entitled “IMPORTANT SAFETY INSTRUCTIONS’
4.
The safety instructions shall include, as applicable to the particular apparatus, the information
and warnings listed before. The wording is capable of being supplements, although not
replaced, by drawing or cartoons.
5.
The symbol shall be shown adjacent to the text of Important Safety Instructions.
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
needed.
– Consult the dealer or an experienced radio/TV technician for help.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE:
Under the influence of electrostatic phenomenon, the product may malfunction and
require user to reset.
Under the environment with surge, the product may malfunction and require user to reset.
-3-
LOCATION OF CONTROLS
1.
Volume Control
11.
LCD Display
2.
Headphone Jack
12.
Handle
3.
SKIP DOWN Button
13.
Speaker
4.
SKIP UP Button
14.
CD Compartment
5.
PROGRAM Button
15.
Antenna
6.
REPEAT Button
16.
AC Socket
7.
STOP Button
17.
Aux-in Jack
8.
PLAY/PAUSE Button
18.
Battery Compartment Cover
9.
Function Switch
10. Tuning Control
AC OPERATION
Connect the plug to the AC socket of the unit and the other end to a standard AC outlet.
ATTENTION
1. Do not plug or unplug the power cable while you have wet hands;
2. When planning not to use this unit for a long time, disconnect the power cable from
the wall outlet;
3. When disconnecting the power cord from the wall outlet, do not pull on the cord in
order to avoid shock risks caused by damaged cable.
-4-
