10
Required Parts
• Wing
• Fuselage
• 1/4-20 x 2" nylon bolt
• Canopy hatch
• Side force generator
• 3mm wing nut (2)
• #2 x 1/4" screw (8)
• 1/4-20 x 2" nylon winged bolt (2)
Required Tools and Adhesives
• Flat blade screwdriver
• Threadlock
Step 1
Place the wing onto the fuselage. Connect the servo leads
and guide them into the fuselage Secure the front of the
wing using the two 1/4-20 x 2" nylon winged bolts. Leave
the bolts slightly loose for now.
Step 2
The final bolt goes into the hole at the rear of the
canopy hatch. Use a flat blade screwdriver to tighten
the bolt. Once tightened, go back and tighten the bolts
installed in Step 1.
Step 3
Slide the side force generators into the wing. The one
with the threaded rod slides in from the top. Secure the
generators using the 3mm wing nuts. Do not over-tighten
the nuts and damage the generators.
Step 4
If you are not planning on using the side force generators,
secure the side force generator plugs to the wing using
#2 x 1/4" screws.
Note
: The SFG's can be easily removed in a
few seconds. Try your Tribue™ 36 with and
without to decide which setup suits your
flying style best.
Step 5
Apply the decals to customize your Tribute 36.
Section 5: Wing Installation
