Hangar 9 Sundowner 36 ARF, Инструкция по сборке, Страница: 35 / 48

35 Hangar 9 Sundowner 36 ARF

2. Slide the cowling on the fuselage until the inner
support of the cowling contacts the fuselage. Use a felt-
tipped pen to transfer the locations from the card stock to
the cowling.

3. Use hobby scissors and a rotary tool with a sanding
drum to remove the material necessary to fit the cowl over
the engine. Work slowly, removing only small amounts from
the cowl at a time. Test fit the cowling periodically to make
sure it is fitting properly. Create a small opening for the
muffler at this time as well.

4. Connect the line from the clunk to the carburetor.
Leave the line long so it can be removed through the cowl
using hemostats.

5. Attach the cowl to the fuselage using two 3mm x
10mm socket head machine screws and two 3mm washers.
The lower screw is installed from the inside of the cowl,
while the upper screw is installed inside the fuselage. Use a
2.5mm hex wrench to tighten the screws.

6. Attach the muffler to the engine using the hardware
provided with the engine. Make sure there is clearance
around the muffler so it does not damage the cowl when it
gets hot. Connect the line from the vent on the fuel tank to
the muffler.

7. Attach the propeller and spinner to the engine. Follow
the instructions provided with the engine to make sure the
propeller is secure.