Hangar 9 PiZAZZ, Инструкция по эксплуатации

Страница: 26 / 39

27
Parts Needed
• Radio system with 3 servos and hardware (not included)
• Fuselage/wing assembly
• Radio packing foam (not included)
• Y-harness (optional—must have if using 4-channel radio)
Tools and Adhesives Needed
• Medium Phillips screwdriver
• Hobby knife
• Drill
• Drill Bit: 1/16"
Step 1. Install the rubber grommets and eyelets in three servos.
Position the servos in the fuselage servo tray as shown, noting
the location of the servo horns. Before installing the servos in
the servo tray, we suggest the servo leads be identified by using
some masking tape with the appropriate letter to designate which
servo it is, e.g., “T” = Throttle, “R” = Rudder, and “E” = Elevator.
Screw the servos in place using the 12 servo screws included
with the servos.
Step 2. Use radio packing foam (not included, available at your
local hobby shop) when you install the receiver and battery.
Step 3. Be sure to attach the servo leads to the receiver prior
to installing the receiver into the fuselage (refer to Radio Set-Up
section). Route the antenna outside the fuselage back to the
stabilizer. Be sure to avoid the elevator and rudder linkages.
Step 4. Wrap the receiver battery in foam and place it in the
fuselage area forward of the servo tray and receiver. We suggest
using layers of foam to hold the battery. Cut another layer of
foam identical in size to the compartment and place it on top of
the battery. Cut slits in the foam to allow the battery lead to exit
the foam.
Section 12: Installing the Radio System