Hangar 9 HAN1300, Инструкция по эксплуатации, Страница: 7 / 16

Step B-3
Install a small washer on each of the two small screws. Apply
Locktite (included) to the small screws. Then, place the screw on
a standard Phillips screwdriver.
Hint: It is helpful to use a
good #2 magnetic screwdriver. Insert through the holes in
the bottom of fuselage and into the mounting holes into the hori-
zontal stabilizer. Securely tighten, then check that the stabilizer is
firmly fixed to the fuselage.
Step B-4
Connect the rudder and elevator pushrod clevises to the rudder
and elevator control horns at the outer most hole. See illustration
below.
Be sure to check to make sure the clevis keepers are over each
clevis. This prevents the clevis from coming open accidentally
during flight.
7
Loc
ktite
Apply a small drop of Locktite
to screw when mounting the
tail assembly to fuselage.
Secure the rudder
and elevator clevis.
Step C: Installing the Main Landing Gear/
Wing Hold Down Dowels
Step C-1
Locate the aluminum main landing gear. The wheels have already
been attached. You should have two screws remaining from the
hardware package. Apply a drop of Locktite to each screw. Then,
insert them through the holes in the landing gear and attach the
landing gear to the fuselage.
Step C-2
Locate the two wing hold-down dowels and insert one into each
of the two holes located in the fuselage, using a careful twisting
motion to install. The dowels should be positioned so an equal
amount is projecting from either side of the fuselage.
Loc
ktite
Step C-1
Mount landing gear to
fuselage with the two
screws provided.
Apply Locktite to threads of the screws
prior mounting to landing gear.
Place the screw with washer
on the Phillips screwdriver
and insert into the hole in
bottom of the fuselage.
Short Screw
Step B-3
Step B-4
Clevis attached to
outer most hole
Clevis
Keeper
Connect clevis to outer most
hole of control horn.
Step C-2
Note: The rudder pushrod is positioned
above
horizontal
stabilizer.