Hangar 9 Extra 300 ARF, Инструкция по сборке

Страница: 23 / 44

23 35% Extra 300 ARF Assembly Manual

6. Mix 30-minute epoxy and glue the wood plate in place
to block the canister tunnel.
Canister Installation
Required Parts
Silicone tubing
Required Parts (not included)
MTW 75 Canister
50mm drop header, 10 1/2-inch header length for MTW
TD75 canister setup
Couplers
Clamps
Required Tools and Adhesives
Hobby knife Felt-tipped pen
Clamps Hobby knife
Vise grip Iron
Masking tape Industrial lubricant
Acid brush Mixing cup and sticks
Ruler or caliper Rotary tool
Cutting wheel

1. The model comes with the canister mount already
installed. Remove the covering from the bay behind the
canister mount by applying 4 pieces of masking tape along
the edges of the section that need to be opened for canisters.
Use a hobby knife to remove the covering.

2. Iron down the edges of the tunnel and remove any
excess covering that may catch air in flight.

3. Pass the silicone tubing through the upper middle hole
and go through each hole in the circumference of the mount
from the inside until you are back at the same middle hole
that you started. Cut off the silicone tubing once finished.
Follow the next 3 pictures as reference.