Hangar 9 Easy Fly 40, Инструкция по эксплуатации

Страница: 37 / 49

37
❑
3. Center the rudder and the rudder servo so that the servo
arm is perpendicular to the fuselage. Mark the plain
rod where it crosses the holes in the servo horn. Using
Z-Bender pliers, make a z-bend at the marked location
and cut off the excess plain rod.
❑
4. Insert the z-bend in the second hole out on the servo
horn. Center the servo so that the horn is exactly
perpendicular to the fuselage and adjust the clevis on
the rudder horn by screwing it in or out until the rudder
is exactly neutral when the servo is centered.
❑
5. Use the same procedure to install the elevator pushrod,
noting that the elevator pushrod exits the rear opening
of the fuselage.
❑
6. The two remaining long plain rods are for the throttle
and nose wheel linkage. Using a sharp knife, cut out
the opening just behind the nose wheel where the nose
wheel pushrod exits.
Section 14: Installing The Linkages
CONTINUED